Amp Trip / 3A DCC Booster Board
These boards can be used to make a locomotive Power District or an Accessory District with a shared power supply. Connect the boards input to your DCC buss and you have additional power independent of that districts booster. A jumper is used to set either Accessory Power Supply or Power District Mode. Each board can supply up to 3 Amps continuous duty and 5 Amp peak with a suitable power supply. These boards work very nicely with the Hex Frog Juicer. The board is Non Auto Reversing.
Board Size: 3″ long x 2.5″ wide x 0.5″ deep including heat sink. We recommend a % Amp power supply such as the DPS016
|701-DAB002||Amp Trip / 3A DCC Booster Board w/o Power Supply||$42.00||$37.80|
|701-DAB002A||Amp Trip / 3A DCC Booster Board w/DPS016 Power Supply||$56.95||$51.25|
5 Volt 4 Amp Power Supply
The ideal power supply for the SwitchWright, this unit is well-regulated and current protected. The wires are pre-stripped and polarity marked. It can support about 40 SwitchWright switch machines. 115V (US) input only (not suitable for 230V).
|701-DSP005||5 Volt 4 Amp Power Supply||$11.95||$10.80|
12V 5A Power Supply
12V 5A 60W switching power supply. Best for powering Quads and Singlets. Plug size is 5.5/2.1 mm. Power supply comes with a US 110V plug. May be used with 240V~50/60Hz power by swapping the power cord. If you add the power jack to screw terminal adapter below you can use this as a general purpose power 12V supply.
|701-DPS012||12V 5A Power Supply||$14.95||$13.45|
16V 4.5A Power Supply
16V 4.5A 72W switching power supply – best for track power. Delivers about 15 V to track when used with our booster above. Plug size is 5.5/2.1 mm. Power supply comes with a US 110V plug. By swapping the power cord can be used with 100-240V~50/60Hz power. If you add the power jack to screw terminal adapter below you can use this as a general purpose power 16V supply.
|701-DPS016||16V 4.5A Power Supply||$14.95||$13.45|